Freeze Kit Model 1.02

Updates from 1.01
----------------
This model now includes notes.

1.02
*Notes slightly off-set numbers. Those were notes I deemed inappropriate to keep and removed them.*
20: Handles here above the main shaft are present for twisting the main valve.
Doing so releases the final agent.
36: Compartment for compressed H2.
38: Compartment for additive agent.
40: Slide buffers. Wouldn't want to overshoot my grip.
48: Joint of spin to shafter.
54: This is the side of the handle.
54.5: This is the other side of the handle.
56: This is the side of the side of the handle.
60: Outside shaft of the device should remain as flat as possible for stackable access in larger quantities.
63: Rubber coated lip of syringe to prevent reaction's effects from driving up the shaft, stealing
the energy from the remaining reactants too early.
65: Exit of needle shaft should be ~3cm wide to allow proper pressure upon press.
66: Main ammonium nitrate chamber.
68: Actually I don't really remember what was supposed to go here.
70: Upper grip should slide down the spin shaft here.
71: And here.
76: And here.
78: Lift for compartment chamber, allows access to loading and unloading.
90: + shaped slider ensures resistance of shaft-entry to keep it at a steady pace.
92: Exposed ammonium nitrate chamber.
94: Tip of the inner shaft finishes process of mixing inner reactants, simply needs air exposure.
95: Outer needle - this needs to be a sturdy metal, something that won't snap when jammed into a surface.
96: Pressure Gauge printed on opposite viewside.
98: Yup. This is slider.
99: Nice, flat, place to palm the injection. ugh, those ones with 3 rings are so awkward and stupid
to fit your fingers into.